drill press table lift
Description:
The on/off push button switch shown is also a 10 amp circuit breaker, wired in
right after the power supply.
The 12 volt power supply was mounted on the back side of the control box via the use of 2 band clamps.
The 200 lb 18" lift motor was an ideal choice and works great.
Images courtesy of Bill Billick,
right after the power supply.
The 12 volt power supply was mounted on the back side of the control box via the use of 2 band clamps.
The 200 lb 18" lift motor was an ideal choice and works great.
Images courtesy of Bill Billick,
Images
drill press table lift
Project By: dave
Skill level: very easy
Category: Home Automation
Tags: drill press, table lift
Viewed: 848 times
Website: www.firgelliauto.com
Other Home Automation Projects
Comments
Add comment
|
|
<< Previous Page
|
Next Page >>